Settings: Security

This function is used to change encryption settsings in the RTMS Echo sensor.

HTTPS Encryption

  1. Click the Settings tab.
  2. In the Security section, click Change. This is a picture of the software.
  3. To enable encryption, click the drop down menu under HTTP and select Encrypted.
      • Encrypted data uses HTTPS protocol.   
      • Not encrypted data uses HTTP protocol. 
      • Enabling encryption will disallow access to HTTP protocol. 
  4. Click Save changes.

    There will be a 3 second delay to allow the server to reset the web server.

  5. The web server will restart and use HTTPS protocol. This may require logging back in to the RTMS Echo.
  6. When encryption is enabled, the Security section will now display "Factory self-signed certificate".

Auto Logoff

  1. Click the Settings tab.
  2. In the Security section, click Change.
  3. Use the drop-down under Auto logoff to select the time the user will be logged out of the web interface.

    The options are: 1 hour, 8 hours, 12 hours or 24 hours.

    Note,1 hour is the default.

  4. Click Save changes.

Password Complexity

  1. Click the Settings tab.
  2. In the Security section, click Change.
  3. Use the drop-down under Password complexity to make changes.
    • Basic: minimum of 4 characters.
    • Enhanced: minimum of 8 characters and must contain three (3) of the following categories: alpha, numeric, special characters, upper and lower case characters.
  4. Click Save changes.